FrSky X-LITE Stick Caps / Extenders
Description
#X-Lite Stick Caps / Extenders The Original Sticks Are A Bit Small And Do Not Provide A Good Thumb Contact Area For My Personal Taste, So I Created These Simple Caps. ####Hint: >If The Caps Do Not Fit Tightly On Your Sticks (This May Slightly Vary Depending On The Filament Used), Just Scale Them A Little Bit (At About 1% Should Do It). ####Print Settings: >- Layer Height: 0.2Mm >- Use Supports (Build Plate Only), 5Mm Support Line Distance >- Infill: 8% >- Use A Raft For Good Adhesion
Statistics
Likes
15
Downloads
0