Needle Point Meter Probe Case
Description
These Are Case For The Snap On Needle Points For Meter Test Leads. There Are Two Sets Of Files One Is For Fluke Needle Points And One For Keysight/Aligent/Hp Needle Points. I Printed With Pla Yellow. The Yellow Is Semi-Transparent So You Can See If The Points Are In The Case. You May Need To Adjust The X Y Scaling In The Slicer If The Inside Bore Is Too Tight. You Should Only Scale It By 0.1 At A Time. Also Keep In Mind You Need To Scale The Cap At The Same Time. The Caps Just Snap On Using The Layer Lines To Hold Them. I Have Had Good Luck With This. Print This Slow I Print At 30Mm/S. Layers = 0.2Mm No Support Required Print Positions See Photos
Statistics
Likes
21
Downloads
0