Fridge/freezer handle modified to Wasco KF3401w and 19.3mm pipe
Description
Out Fridge Handle Broke Again, And While Searching For At Printable Replacement I Found Https://Www.Thingiverse.Com/Thing:1460492 By Fsvit66 To Be The Closest Match To Our Fridge, Only It Is A Bit Too Thick To Fit Behind The Panel Beside The Fridge Door And I Didn'T Have A Matching Pipe Available. Our Fridge Is A Wasco Kf 3401 W. This Remix Is A Bit Thinner At The Front; 7Mm, And For A Pipe Diameter Of Approximately 19.3Mm (Believed To Be An Old Tent Pole). I Replaced The Original Lids With A Closed Side. Only One Holder Is Designed Here -- The Other Is A Mirrored Copy That I Used My Slicer To Create (In Slic3R, Simply Drag Another To The Plate, Right-Click And Mirror, Then Rotate Around To Print With The Closed Side Down. Cut The Pipe To A Length Of Approximately 14Mm More Than The Screw Distance. Sketchup Source Is Included -- This Was Made By Importing The Stl Since My Version Was Unable To Open The Original, So If You Want To Make More Changes You Might Want To Consider The Original Stl Instead Of Mine As A Starting Point.
Statistics
Likes
11
Downloads
0