Stove Knob: ok...so there are non manifolds, but it prints. you might be able to fix them better than me.
Description
I Printed It. It Works. An Old Tappan Gas Stove Missing 4 Knobs, I Printed All New Ones, Because I Had To Design A New One In Sketchup, Since All The Other Knobs On Thingiverse Didn'T Work For A Regular Stove. And I Worked Way Too Much On It As A Newbie. I Tried The First Print Out On A Fridgidaire, And It Works Good. 1 3/4" Diameter Of Flange, 1/2" Depth Of Flange, 1/2" Tall X 5/16" Thick "Thumb Turn" 1" Depth" Receiver Hole For 3/8" Round, Bisected 1/4" By Flat (See Knob Back Pic) 5/8" Overall Shaft Protrudes 1/2" Below Solid Knob. (Full Support, For Print, Pull It Off Warm For Easy Removal, Like Pulling A Ribbon.) For Pla, .27, 85%, Full Support, Because Of End Receiver. 3 Hours, 08Minutes. It Has A Couple Lines Across Face( See Pic), But If You Don'T Care, I Included X3G File For Sd Card, And Gcode, Otherwise, You Can Fix The Non Manifoldness, And Generate New Gcode.
Statistics
Likes
24
Downloads
0