Monitor Stand
Description
A Four Part Monitor Stand Meant To Hold A 24 In Monitor. Monitor Tilt Is Adjustable. If Anyone Wants A Different Height, There Is A Model Attached With Different Height Positions For The Vesa Mount. You Need 350Mm Of Print Height, And A 300Mm^ Bed To Print The Base In One Piece. If You Use This Model Please Consider Donating. This Base Was Printed With A 0.8Mm Nozzle, Two Outer Layers, And 0.25Mm Layer Height. Infill Was 50% With A Triangular Pattern. The Bolt And Grapel Were Printed With A 0.4Mm Nozzle, Five Outer Layers, And 0.2Mm Layer Height. Infill Was 70% With A Triangular Pattern. The Vesa Mount Was Printed With A 0.4Mm Nozzle, 3 Outer Layers, And 0.2Mm Layer Height. Infill Was 50% With A Triangular Pattern. If You Intend To Use This Part Make Sure You Are Using High Quality Filament, And At Minimum, The Settings I Used About, If Not More. With My Filament, The Stand Was Able To Hold 20Lbs For 15 Minutes Without A Problem. If You Would Like Help With Your Project, Please See My Website. Www.Bitdrafted.Com
Statistics
Likes
202
Downloads
0