Monoprice Maker Select Plus - Dial Indicator Mount
Description
This Is A Dial Indicator Mount I Made For My Monoprice Maker Select Plus (V2, I Think). I Wasn'T Too Keen On Having The Indicator Slide Around On The Rails, So This Uses **2X #6-32 Screws** (3.5Mm Od) To Mount To The Extruder Stepper Motor. (I Used Hex-Head Pc Card Screws That I Have A Billion Of.) This Mount Requires A Dial Indicator With A Lug In The Back, As It Uses A Locking Pin To Secure It Solidly To The Mount. That Probably Sounds A Bit Wiggly, But I'Ve Found That Even With My Crappy Parameters, It Formed A Solid Mechanical Union With The Mount. This Will Mar The Paint On Your Stepper, But I Don'T Mind. Add A Pad If This Worries You. Dial Indicator: Https://Www.Amazon.Com/Triton-Indicator-0-001-Graduation-Travel/Dp/B016R3Glb0/ Screws: #6-32 Pc Screws, Or Any 3.5Mm Screw (Holes Are 3Mm Without Thread): Https://Www.Amazon.Com/Uxcell-Plated-Phillips-Computer-Fastener/Dp/B01N3Qtotf
Statistics
Likes
8
Downloads
0