Radiant Tube for 2 Inch water hose
Description
It Is A Simple Water Hose Jet Tube. It Only Makes A Stong And Steady Water Flow Out Of The Nozzle. This Jet Tube Is Designed For The 42 Mm Water Hose. It Fits Snug Into The Hose An You Only Need To Wind It Up With Wire Or Some String To Make It Watertight. I Added Some Other Files: This Is An Other Version Of The Tube, Its A New Main Part Wich Will Be Connected To A Screw Head. The Third Part Is To Mount The Hose Without Wire Or Clamp. Its Like A Quick Connector: Cut The Water Hose With A Sharp Knife Or Scissors. Attach The Quick Connector To The Main Part, Attach The Hose Over The End Of The Main Part. Then Only Pull Back The Quick Connector. Its Cone Will Clamp The Hose Firmly To The Sharp Edge. It Was Printed On An I3 Mega And I Used A Skird Around The Bottom Of The Tube. It Is Not Easy To Screw The Parts Together. Maybe The Gap Is A Little Bit To Small In The Windings. But I Had Succes With Some Sandpaper And Screwing It While It Was Wet.
Statistics
Likes
0
Downloads
0