Keystone Surface Mount (single)

Description

This Is A Remix Of Jsadusk'S Thing With Added Mounting Flanges For Use In My Tinker Friendly Ikea Lack Printer Enclosure. These Make It Very Easy To Disconnect/Reconnect The Case Leds, Spotlight, Mixing Fans, Cooling Fan, And Filament Run Out Sensor That Are Mounted On The Removable Enclosure Top. It Requires 2@ #8 Wood Screws And Of Course A Cat6 Keystone Jack To Complete. The Original Blank Design Was About 1Mm Too Small For My Keystone Jacks. So They Wouldn'T Fit At All, Even With Some Trimming With A Razor. So I Also Adjusted The Fit With This Remix. Keystones Now Snap In Fairly Easily. There Is A Resulting Small Gap On 2 Sides Of The Keystone'S Face Once Installed, But It'S Barely Noticeable And They Still Hold Very Securely.

Statistics

Category

Tags