Triple Threat - E3D Carriage Bowden Mount for AM8/A8
Description
---------------------------------------------------------------------------------------------------------- **This Thing Has Now Been Redesigned And Tested And Is Ready For Printing. Thanks For Your Patience Everyone. Hope You All Enjoy (Be Sure To Download All The New Files)** ----------------------------------------------------------------------------------------------------------- **Triple Threat - E3D Carriage Mount** This Thing Is An All In One E3D V6 Carriage Bowden Mount For The Anet Am8/A8 And Similar Type Printers. While There Are Quite A Few Really Good Designs On Thingiverse They Are All Missing One Thing Or Another, Like A Tensioner Or A Cable Chain Attachment Etc. This Design Aims To Include All These In One. It Has Three 40Mm Fans, One For The E3D And Two Part Cooling Fans. X Belt Holder/Tensioner And A Cable Chain Head Attachment As Well As An Attachment For A 3Dtouch/Bltouch Sensor. Join The Two Part Cooling Fans Together And Then Connect Them To Your Motherboard (So They Run In Parallel). **Update - 28-01-2019** I Have Uploaded The Complete Assembly Step File For Those Who Need To Tinker. **Bom:** 3X 40Mm Fan - If Your Fans Have A 3Mm Countersink Use The "Cs-Back-Vent" 2X M3X10Mm Button Head - Probe Mount 2X M3X10Mm Button Head - 3Dtouch/Bltouch Probe 2X M3X10Mm Button Head - Chain Head 8X M3X14Mm Cap Screw - Side Fans (If Your Fans Have A 3Mm Countersink Use M3X10Mm) 4X M3X50Mm - Assembly Mounting (If Your Fans Have A 3Mm Countersink Use The "Cs-Back-Vent") 3X M3X20Mm Button Head - Belt Holder 1X M3X30Mm Button Or Cap Screw - Belt Tensioner (The Anet A8 Has One Of These Spare) 14X M3 Nut **Additional Required Files:** 1) Grab The Belt Holder/Tensioner From The Link Below, Because The Tensioner Has A No Derivitives Licence (Rolling My Eyes) You Will Need To Use A 3Mm Or 3.5Mm Drill Bit And Drill A New Mounting Hole Right Through The Tensioner From The Hole In The Backplate. My Original Design Included The Tensioner With One Small Change To The Mounting Holes But I Cannot Share That Due To The Licence. So Either Drill The Hole Or Modify The Tensioner If You Know How (Or Only Use 2 Of The 3 Mounting Holes). Https://Www.Thingiverse.Com/Thing:2425783 2) Grab The Chain And Motor Mount Here: Https://Www.Thingiverse.Com/Thing:2104821 Make Sure You Insert All Nuts In Their Place Holders Before Assembly As Some Thought Will Have To Go Into In What Order You Should Assemble It. **Print Infill And Support** Back-Plate = 60% Infill - No Support Back-Vent/Cs-Back-Vent = 60% Infill - No Support Clamp-Assembly = 60% Infill - Support Touching Build Plate Only Fan-Clamp = 60% Infill - Support Touching Build Plate Only Chain-Head = 80 - 100% - No Support Probe-Mount = 100% - No Support **Probe Offset:** Define X_Probe_Offset_From_Extruder -34 // X Offset: -Left +Right [Of The Nozzle] Define Y_Probe_Offset_From_Extruder -33 // Y Offset: -Front +Behind [The Nozzle] Backplate Design Taken From: Https://Www.Thingiverse.Com/Thing:2668564
Statistics
Likes
136
Downloads
0