TBS Disco Gimbal GOPRO holder and arm for 2208 motors
Description
Although I Created These Files From Scratch So Its Not Technically A Remix(By Thingiverse Standards), But I Feel As This Should Be Seen When People Look At The Original By Adi380 These Parts Were Designed To Be Used With 2208 Gimbal Motors, They Were Also Designed To Center The Gopro As Much As Possible While The Craft Was Powered Off. Picture Included Is How The Gopro Sits On My Disco (Clone) When The Gimbal Is Not On). Keep In Mind The Gopro Fits Tightly Inside The Mount, Did Not Want To Ever Worry About It Falling Out. If You Dont Want That Scale It Up Very Slightly. The Design On The Back Of The Mount Allows You To Use Your Fingers To Press The Gopro Out. Version 2 Of The Arm Only Changed The Screw Pattern Of The Motor So The Wire Would Not Stick Out Forward. I Have Not Printed V2 I Just Made The Changes As I Had Forgotten To Change It. If You Are Okay With The Motor Wires Sticking Forward Just Print Version 1 (See Pic For Version 1)
Statistics
Likes
4
Downloads
0