MightyMouse (My interpretation of Neato Pipsqueak)

Description

This Is My Take On The Neato Frames Pipsqueak. This Is Meant To Be A Tribute To Them, And Not A Substitute. I Hope They Start Selling These Again Soon. Carbon Would Be A Lot Stronger Than Filament. If You Are Interested In The Frame, You Can Buy One Of Theirs From Here Http://Www.Neatoframes.Com/Product/Pipsqueak/ If You Want A High Quality Version Of The Latest 3D File (Not Shown Here) Then Check Out Https://Www.Classifiedfpv.Com/ That Aside, I Did My Own Take On The Frame So It Is Not Exactly The Same. - There Are Two Base Plate Styles, One Is Flat Like Carbon Fiber But Has A Lot Of Flex, The Other Is Reinforced To Be More Firm If You Want To Fly The 3D Print. The Reinforced Flys Great, I Recommend Using The Latest Revision Though. And Apply Some Sort Of Loctite, Glue, Or Sealant On The Motor Mount Screws To Keep Them From Backing Out. - The Base Plate Slots Are Intended For A 20X20 Stack And You Can Fit A Thin Battery Strap Through As Well. - The Slots In The Top Are In Case You Want To Have A Top Battery In A Toilet Bowl Config, Or You Could Make A Camera Work Too. - The Square Cutouts Are Intended To Allow For Camera Tilt. - The Diagonal Slots Are For Cooling And If You Put Something On The Bottom With A Button That You Want Access To, There Is A Chance You Can Make That Work As Well. - The Skirt Is An Improvement From The Original And Is A Complete Rebuild To Match The Top And Bottom Plate. It Is Thicker Everywhere And Has Support To Hold Everything In Place If You Print In Tpu. You May Need To Trim The Area Above The Camera To Allow For Full Up-Tilt. You Can Cut It Away Completely And It Will Remain Solid Since The Posts And Camera Fasteners Hold Everything In Place.

Statistics

Category

Tags