Hydraulic lift V2
Description
This Is My Second Try To Design A Hydraulic Lift / Ramp. The New Stand Is On The Right Side In The Picture, Had It Printed Just Once Till Now. Print The .Stl Two Times To Get A Model That Holds Hotwheels Cars On Its Own In Every Desired Height. Maybe The Sliders Need Some Support, Maybe It Could Be Achived With Bridging. Cause My Lazy Adjusted Printer Needed Support I Printed It With Some. Therefore It Needed A Little Post-Print Sanding. Also A Little Bit Of Infill Could Be Good, I Had None And Got A Small Hole On The Top Of It. I Printed With These Settings: .3 Nozzle .1 Layer Height 0% Infill 6 Shells Bottom 6 Layers, Top 8 Layers 196° / 60° Pla
Statistics
Likes
164
Downloads
0