Odroid C2/C1+ Case (60mm cooling fan)

Description

Another Odroid Case I Made. Should Also Fit A C1+ This One Is For A 60Mm Cooling Fan That'S 11Mm Thick. It Requires 4 Small Screws -> 2.5Mm Diameter, 4-6Mm Long Screws With Maximum 5.2Mm Diameter Head. The Other Case I Made Was Too Large And Bulky, And With An Open Funnel That Sucked In Air And Dust, I Wanted To Fix That. I Didn'T Want The Fan Face Down On The Heatsink Because It Would Just Suck In Dust From The Top On To The Board. I Designed It So That It Draws Air From One Side To The Other (Without It Being Too Tall). Included In The Files Is The 60Mm Fan And A Mock-Up Of The Odroid C2 For Anyone Wanting To Use It To Make Their Own Version. ---- Settings ----- I Printed At 0.2Mm Layer Height. Base.Stl Support Infill Percentage: 100% Horizontal Offset From Part: 0.5Mm ^^^^ Use Those Settings To Make Removing The Support Structures Easier On The Base.Stl File. Doge Donations: D5Cqng1Nhcrweyfhv5Lajnrmp54Mvym2Az Much Appreciated!

Statistics

Category

Tags