Snapping USB support Phone holder
Description
This Is A Phone Holder Which I Designed For My First Tech Challenge Robot. It Is Designed With Two Priorities In Mind: Usb Support And The Ability To Hold The Phone Securely. The Design Allows The Phone To Snap In, Being Inserted Into The Top, And Snapped In On The Bottom, And Provides Optimal Usb Support On All Sides The Usb Support Is Designed To Be Used With A Right Angle Phone Plug (Like [This](Https://Www.Amazon.Com/Cablecreation-Degree-Micro-Adapter-Female/Dp/B01Lx00U5U) Or [This](Https://Www.Amazon.Com/Sanoxy-Micro-Right-Angle-Adapter/Dp/B005Gi2Vmg)), To Be Inserted, Before Being Snapped Into Place With The Latch. This Is An Improvement On My Previous Design, The [Moto G4 Play Phone Mount With Usb Support](Https://Www.Thingiverse.Com/Thing:2746847/Edit). It Provides Added Security For The Right Angle Connector, And Allows The Design To Be Actively Held In Place, Without The Risk Of Torsional Loads While Putting The Phone In The Case, As Was Previously The Case. It Can Be Printed In Either Abs Or Pla, And Holds A Moto G4 Play Very Securely, Which Can Be Useful If A Steady Phone Mount Is Needed For Computer Vision Tasks. All It Takes To Assemble Is A Couple M3 Screws To Hold The Latch Onto The Phone Holder Body **Quick Note:** The Clip For This Piece Was Designed To Clip Well When Using Abs Plastic Which Is A Little More Flexible Than Pla Plastic, So You May Need To Slightly File The Nub In Order To Get The Piece To Clip Easily If You'Re Using Pla Plastic This Phone Holder Was Designed By Ftc Team Robocracy 9773. You Can Learn More About Us On Our Website: Www.Ftcrobocracy.Org
Statistics
Likes
9
Downloads
0