FLSUN COREXY Z Mount replacement
Description
This Is The Z Axis Stepper Motor/Bearing And Linear Motion Shaft Mount (Top And Bottom) Replacement For The Flsun Corexy Printer (2018 Pre-Sale). It Should Work With The Official 2018 Release Model. (The Flsun Corexy Is Also Known As Flsun-G. Not For The Cube) Warning: It Does Not Fit The Flsun Cube As The Lead Screw And The Linear Motion Shaft Are Offset Differently. The Original Mounting Plate And Shaft Holder Were Installed Unevenly, The Position Can Be Off As Much As 5Mm. This Can Lead To Bent Z-Axis And Layer Shifts. This Design Is Based On "Flsun Cube Z Motor Mount" By Devians88. Print The 4Mm Version If U Are Using The Supplied M4 Bolts And Nuts Print The 5Mm Version If U Are Using 5Mm Bolts And Nut. The Plates Are 10Mm Thick, So You Have To Use A M5 X 14Mm Bolt Use A Washer With The Bolt To Spread Out The Load When Installing To The Frame. For Installation: The Distance From The Edge Of This Mount To The Front Of The Printer Is 102Mm I Also Included Printed "Tools" For Alignment. Update: I Have Created A Z Axis Top Mount For The Screw Thread Bearing And The Z Axis Rods Under This Creation. Same Alignment Distance Applies. Update: 20 Jul 18 - Added Z Axis Limit Switch Mount (M4)
Statistics
Likes
35
Downloads
0