Solidoodle 2 - E3D - Flexion Extruder Mount
Description
This Is A Mounting Adapter Block For The Flexion Extruder To The Solidoodle 2 (Pro) 3D Printer. I Have Split The Part Into 3 Seperate Chunks In Order For It To Be Printable Without Support Structures. As I Am Using The E3D V6 Hotend, This Is Specifically Designed To Work With The E3D Hotend, The Flexion'S Own Hotend Might Work, However, This Was Not Tested - Mainly Because You Will Most Probably Need One Of The Heatbed-Mods Available Out There To Be Able To Reach The Heatbed With Any Other Hotend. I Printed This Using 100% Infill In Abs, Other Settings May Work Just As Well But Have Not Been Tested. * Even This Is Not A Direct Remix Of The [E3D V6 Bolt On Mount For Solidoodle](Https://Www.Thingiverse.Com/Thing:431363) By Mdroman, It Is Inspired By His Work, Therefore I Feel Like Mentioning His Credits Here. :) Update: I Have Added A Little Extra Bulge On The Right Hand Side To Avoid The Sliding (X-Axis) Part Getting Stuck While Homing At The Limit-Switch.
Statistics
Likes
1
Downloads
0