Deathclaw 2
Description
Last Year I Remixed A Deathclaw For Warmachine. I Cut It Up Into Printable Chunks, And Scaled It Down. It Took Me A Week To Do, Because I Was Still New. I Made A Lot Of Mistakes. One Of Those Prints Sits On My Desk And Every Day I Look At Those Mistakes. Yesterday, In A Couple Hours, Using All The Things I'Ve Learned Over A Year Of 3D Printing And Model Work, I Remixed The Deathclaw Again. Improvements: - I Decided To Utilize 1.75Mm Pla For Pins Instead Of Trying To Plan And Model Pins Into The Parts. - Scaling Is Better - Fit Of Parts Is Better - Better Base Design Incorporates The Texture From The Original Models Base. - New Modeling Techniques Caused Less Detail To Be Lost This Model Is Scaled For The Game Warmachine, But It Should Be About Right For D&D As Well. During Assembly I Found It Very Handy To Have A Small 1.75Mm Drill Bit On Hand To Clean Out The Holes. I Used Ca Glue, Which I Find Works Very Well On Pla. The Most Difficult Part Of Assembly Was Figuring Out The Right And Left Shins. I Would Recommend Building From The Body Out. If You Start With The Base And Feet You Are Going To Have A Bad Time.
Statistics
Likes
93
Downloads
0