FLSUN COREXY Z Axis Top Mount
Description
This Is The Z Axis Top Bearing And Linear Motion Shaft Mount Replacement For The Flsun Corexy Printer (2018 Pre-Sale). It Should Work With The Official 2018 Release Model. Warning: It Does Not Fit The Flsun Cube As The Lead Screw And The Linear Motion Shaft Are Offset Differently. The Original Mounting Plate And Shaft Holder Were Installed Unevenly, The Position Can Be Off As Much As 5Mm. This Can Lead To Bent Z-Axis And Layer Shifts. Print The 4Mm Version If U Are Using The Supplied M4 Bolts And Nuts Print The 5Mm Version If U Are Using 5Mm Bolts And Nut. The Plates Are 10Mm Thick, So You Have To Use A M5 X 14Mm Bolt Use A Washer With The Bolt To Spread Out The Load When Installing To The Frame. For Installation: The Distance From The Edge Of This Mount To The Front Of The Printer Is 102Mm Refer To Https://Www.Thingiverse.Com/Thing:2983607 For The Z Axis Motor Mount. Update 6 Jul 18: Replaced With Version 2 To Have Bigger Thru Hole For The Screw Thread. In The Previous Version, The Bearing Movement Was Rubbing.
Statistics
Likes
17
Downloads
0