Tronxy P802 Power Supply Switch Mount
Description
This Is A Power Supply Switch Cover For Tronxy P802Ma. It Is Mounted By Just 3 Screws As Seen In Picture. There Is No Need To Remove Original Power Supply Module To Install It. Once Printed, It Can Be Installed In 10-15 Minutes. Just Remove 2 Screws From Back Of Frame, Mount The Printed Part, And Re-Apply The Screws. 3Rd Screw Will Go On The Original Power Supply Metal Plate Inside The Lower Most Hole. While Looking At Stl, The Mount Is Upside Down. Print Like That Only. Note: Supports Are Already Incorporated In To The Design. So Select No For Supports In Your Slicer Settings. I Selected 8Mm Brim To Be Printed For Extra Adhesion.
Statistics
Likes
3
Downloads
0