Little Monster Duet Wifi Enclosure with Backlighting
Description
Update 07-07-18: -Made Access To Sd Card, Reset Button, And Usb Easier And More Centered. -Fixed Wifi Cutout To Be Centered On The Chip -Centered Wifi Logo And Increased Dimensions Over The Wifi Antenna -Fixed Wifi Insert So The Interference Dimensions Are Greater (More Slop, .15Mm At The Edges) And The Insert Is Directly Over The Led Without Prodtruding Below The Cutout. This Should Give Better Illumination Of The Wifi Logo. -Adjusted Tevo Insert To Be .5Mm Off The Front Edge Of The Board To Better Capture The Red Leds When The Hotend Is Not Heated To Do: -Figure Out How I Want To Mount The Leds In The Tevo Logo For The Hotend. Thinking Inserted Perpendicular To The Edges Pointing Towards Lid. But I Want To Minimize Backwash Into The Usb/Sd/Reset Cutout. For Now, I Recommend Putting Them In The Bottom Corner. Things Are Crazy Bright As-Is. -Fab-Up A Cover Mounted On Top Of The Fan To Mirror The Cover Of The Power Supply. A (Not So) Simple Box For The Tevo Little Monster. Big Thanks To Worekarolis, Hergonoway, Kenavn, And Blitzjon For Their Hard Work Making The Bits I Was Inspired By. The Base Came From Worekarolis And Hergonoway. -Modified Joint For 1.75Mm Filament As A Hinge-Pin -Modified Geometry Of The Joint -Added Friction Fit "Clasp" For The Lid At The Front -Added Backlit Wifi Indicator (Print Clear) -Added Backlit Tevo Logo (Print Clear And Install Before The Board. -Cleaned Up The Front. Now The Blue Leds Do Not Need To Be Attached To The Lid. Inserts Can Be Printed In A Color Of Your Choice. The Inserts Are Made With A .1Mm/.2 Degree Clearance. The Pieces They Fit Through Have Bevels On The Backside For Ease Of Alignment. I Hope Your Printer Is Accurate, Because The Box Front Is Brutal To Print The Logo. I Had To Manually Add S3D Supports.
Statistics
Likes
11
Downloads
0