Prusa MK2S MK2.5 and MK3 Half/Full Bear Anti-vibration feet
Description
A Foot To Be Used With Squash Balls And Any 2020,2040,3030 Extrusion Frames. It Uses An M5 Screw To Attach The Corner Of A Frame. I Used 2 Dot Squash Balls With Excellent Results. Print The Feet Wide Brim Side Down I.E. The Side With A Flat Edge. You'Ll Only Need Supports From The Bed To Support The Middle If You Want A Clean Finish. Mine Printed Fine Without Supports, With An Uneven Finish Inside But As You Don'T See That - I Wasn'T Fussed.
Statistics
Likes
17
Downloads
0