Z-extension for Maker Select v2
Description
Chopped Off The Lower Part Of A [Recent Z Rear Brace With Extension Part](Https://Www.Thingiverse.Com/Thing:2990990) I Did, In Case Someone Wants The Z Extension Without The Z Rear Brace. This Puts No Stress On The Upper Cross-Brace Of The Frame. **Tips** - I Printed These With Large Flat Side On The Bed (The Side With The Hex Nut Holes). It Puts A Lot Of Supports In The 2Mm Gap -- You Can Remove These With Thin Needlenose Pliers, But Biggest Help Was To Use The Scraper That Came With The Printer To Clear The Supports From The Gap. - **Warning!** There Is Very Little Clearance Between The Inside Edge Of These And The Z Frame Holder! So When Hitting Those High Z Heights (> 160Mm) Be Sure That The Lower Screws On These Parts Do Not Stick Out. Recommend M3 X 10Mm Screws. I Only Had M3 X 12Mm So I Added Another Nut On The 'Head' Side Of The Screws To Keep It From Sticking Out The Other Side. - The X Axis Brace Is Still Mounted On The Front Using The Top Holes. I Think It'S Best To Ensure That The Z Axes Are The Same Distance Throughout A Print. I Put It At The Top Of Those Holes (See Picture).
Statistics
Likes
5
Downloads
0