Prusa MK3 Mosquito Hotend Extruder
Description
!Update! There Is A Newer Version Of This Using The Prusa 'Dyson' Technique At: Https://Www.Thingiverse.Com/Thing:3357264 This Thing Replaces The Stock E3Dv6 Hotend On A Stock Prusa Mk3 With Slice Engineering’S Mosquito Hotend.This Installation Uses The Existing Mounts And 3Mm Hardware Found On The Prusa Mk3. You Will Need To Provide A Short (Approximately 40Mm) Piece Of Ptfe Tubing To Complete The Install. Petg - 0.2 Mm Layer - 20% Infill To Get The 'Hot' And Logo Emphasis On The Cover I Used Prusacontrol W/Color Change Set At 1 Mm It Is Highly Recommended That You Use A New Thermistor And Heater Cartridge. The Existing Ones In The E3Dv6 Hotend Have Been Bent 90 Degrees And Lay Alongside The Heat Block Which Can Make Them Brittle Over Time. The Mosquito Has The Cables Coming Out Straight As They Were Manufactured And They Do Not Touch Nor Run Along The Heat Block. Video Of Installed Hotend: Https://Www.Youtube.Com/Watch?V=Ekngtphet-8
Statistics
Likes
57
Downloads
0