LCD2004 5-Button Lidded Enclosure
Description
14/07/2018 - Further Tweak To Back Panel. 13/07/2018 - 0.5Mm Increase To Distance Between Screw Holes In Case Front And Back (On The Longer Distances). - Increased Width Of Gears And Related Components To Improve Stability. - If You Printed The Front And Back Before This Update Then I'D Recommend Putting The Screen In The Case Front, Putting The Screws Through Fully Then Pushing The Case Back On Carefully Until It'S Fully Flush With The Case Front Edges. Then Start Putting The Nuts In Position As Far As You Can. Finally Tighten The Screws To The Nuts To Pull The Nuts Into The Case Back. Remember To Loosen Them Slightly After Doing This To Release Any Excessive Tension. I Don'T Like The Mass Of Blue Light My Lcd2004 5-Button Gives Off At Night. I Designed And Built An Enclosure For It With A Flip Cover And An Attachment To Mount It To The Outside Of An Enclosure. Alternate Mounting Methods You Could Just Print The Case Front, Case Cover Clips And Case Back And Use The Am8 Frame Mounts (Lcd Base Left And Lcd Base Right) With Longer Screws To Mount This Design To Your Am8. See The Am8 Design From Pheneeny - Https://Www.Thingiverse.Com/Thing:2263216/ Please Let Me Know Your Thoughts And If You Have Any Suggestions, Ideas For Improvements.
Statistics
Likes
28
Downloads
0