Prusa i3 MK3 Spool Holder Adapter and Filament Guide for IKEA Lack Enclosure

Description

This Is A Spool Holder Adapter Block And Filament Guide That Can Be Used To Allow The Prusa I3 Mk3 Spool Holder To Be Mounted To The Top Of An Ikea Lack Table Enclosure. The Adapter Can Either Be Glued Or Screwed Down With 4Mm X 30Mm Wood Screws. The Filament Guide Has A 2Mm Channel For The Filament To Pass Through. It Requires A 1/4" X 11-1/4" Channel To Be Cut Into The Table (Make Sure This Is Inline With Your Extruders X-Axis). The Best Way To Do This Is To Use A Jigsaw. Glue It Down Using Ca Glue. If You Do Not Have A Jigsaw Then You Can Use The Included Drill Guide And A 1/4 Drill Bit Then Patiently Drill Holes Along The Table To Create A Channel. The Rest Can Be Cut Away With A Utility Knife. Make Sure You Drill All The Way Through To Create A Channel On Both Sides Of The Table.The Finish Will Be Rough But No Worries, The Filament Guide Will Cover It Up :)

Statistics

Category

Tags