Tevo Little Monster - Volacon Fan Duct with DC42 IR Sensor Mount - MK2
Description
Done Some Updates To My Fan Duct For Tevo Lm. I Wanted To Direct The Air More Towards The Nozzle As Well As Raise The Bottom Of The Ducts As I Was Getting A Little Bit Of Catching On Prints That Were Curling. I Also Raised The Ir Sensor Mount Up A Little For The Same Reason As The Ducts And Set It A Few Mm Back From Hotend As It Was Getting A Little Hot When The Hotend Was At 400*C. I Also Set The 40Mm Fans Back Another 0.5Mm So They Don'T Overhang On Abs Prints That Shrink A Little. The Other Changes Are Less Noticeable As They Have Been Made To Prevent Layer Lamination/Warping Issues With Super High Temp Plastics Like Polycarb And Peek. Printed In Polycarb Seems To Be Holding Up To Constant Bed Temps Of Over 150*C (Up To 175*C So Far) No Problem Bltouch Mount For This Duct Https://Www.Thingiverse.Com/Thing:2983696 Additional Add On'S For Tevo Lm To Go With Duct Here Https://Www.Thingiverse.Com/Redemptioner/Designs Https://Youtu.Be/Thkkfkimr4O
Statistics
Likes
11
Downloads
0