Berd Air Bender & Drilling Jigs
Description
This Is My Own Design Of A Berd Air Bending And Drilling Jig, I Have Included Several Pictures To Show How It Is Used, The Holes In The Tube Are At 45 Degrees The Reason For This Was Because I Found The Normal Straight Drilled Tubes Didn'T Cool Fine Points To Well And The Nozzle Heat Would Spoil The Finish, The Aluminium Tube Used Was K & S 8101 Round Aluminium Tube (Pack Of 3) 3/32" Dia X0.014" Wall And Can Be Found Here, I Used A 1Mm Drill Bit In A Pin Vice / Chuck Https://Www.Ebay.Co.Uk/Itm/K-S-8101-Round-Aluminium-Tube-Pack-Of-3-3-32-Dia-X0-014-Walls-X12-Long1St/361287460750?Sspagename=Strk%3Amebidx%3Ait&_Trksid=P2060353.M2749.L2649 Note: You May Need To Use A Little Wet And Dry To Sand The Bender Centre Pin To A Nice Fit Or Ream The Hole, Use A 3Mm X 10Mm Cap Head Screw To Hold The Roller On The Holes On The 45 Degree Jig Come Out At The Opposite Side Off The Jig Due To The Angle. 28-04-19 Added Two New Stl Files A New 45 Degree Drilling Jig With A Slight Error Correction From The First One And, A Straight Drilling Jig For Those Who Would Prefer The Holes Straight, Also Added A Little Notch To The Side Of The Jigs Inline With One Of The Holes To Help Line It Up Tube Support Can Be Found Here Https://Www.Thingiverse.Com/Thing:3044295
Statistics
Likes
82
Downloads
0