Magnetic Photo Frame
Description
I Wanted A Nice Strong Magnet To Hold An 8X10 Picture On My Mother'S Refrigerator And Aside From The Simple Fridge Magnets, I Couldn'T Seem To Locate One On Thingiverse. Then, While The First (Basic) Design Was Printing, I Got Fancy And Added A Few Effects To The Design - Squiggly And Asian Were Born From My Boredom. The Design Is For The 6X3Mm Neodymium 6Mmx3Mm Magnets (Actually 2.5Mm) That Are Recommended In Gstgeorge'S Design For The Push Pin Magnet. If You Check Amazon Or Aliexpress For Them You Should Have No Problem Locating Them. My Printer Allowed Me To Print And Simply Force The Magnets Into Place Without Any Glue But You Might Find You Need Some Superglue If You Find The Magnets To Be A Little Sloppy. The Plain And The Squiggly Were Created To Be Printed Upside Down So The Hole Doesn'T Get Deformed For The Magnet. However, Due To The Design Of The Asian Style One, I Had To Add A Small Support In The Middle Of The Hole Because It Can'T Be Flipped Upside Down To Print. It Seems To Have Worked Well For My Printer And The Support Should Easily Snap Out Of Place When You'Re Done.
Statistics
Likes
7
Downloads
0