GameCube Face Buttons (A, B, X, Y)

Description

The Original Design For The Gamecube Buttons Were Not Entirely Accurate To The Original Buttons. When I Tried Using Them In My Controller They Did Not Give The Correct Feel When Pressing Them. I Decided To Go In And Add The Small Plus Attached To The Button And Add Some Custom Supports To Avoid Using Support In The Entire Button. The Custom Support Was Made With A 0.06Mm Layer Height In Mind, But Should Work Up To 0.15Mm. I Will Update Once My Test Is Complete With Results Compared To The Original Design. The File Is Also Much Smaller Than The Original. Update: The A-Button Printed Perfectly And Feels Just Like The Original, There Was A Small Problem With The Original File Where The Center Pole Was Too Long, But That Has Been Fixed. Alongside This, I Have Remade The Other 3 Main Buttons And So Far Have Tested Them All. Enjoy!!

Statistics

Category

Tags