AR Wing / Recruit GPS Perch
Description
I'M Working On A Build With An Ar Wing (Same As Rmrc Recruit) And Needed A Flat Spot To Mount My Gps Receiver. I Decided To Mount It On Top Of The Fuselage Between The Motor And Hatch, But Didn'T Want To Cut Down Into The Foam There Since It'S A Little Thin, And The Tab On The Back Of The Hatch Need Something To Engage. I Made This Simple Little Piece To Match The Contour On Top Of The Fuselage. I Glued It In Place With Ca Glue. I Printed Mine With Petg Since It Was Already In My Printer, But Pla Should Be Fine. It'S Sized Approximately 28X28Mm To Fit The Bn-880 Gps Module I'M Using, Which I Stuck On Top Of The "Perch" With Double Sided Foam Tape. There Is A Wider/Taller End, That'S The Front.
Statistics
Likes
28
Downloads
0