Comma 2 - Accord 10th gen dash mount
Description
Dash Mount For A Comma 2 On A 10Th Gen Accord'S Display. It'S Held From Sliding In My Setup Using Outdoor Command Strips (Outdoor Needed For High/Low Temp Resistance). This Makes It Damage-Less To The Car. #Printing: **Must Use Abs** - Pla Will Warp Really Easily In A Car #Needed Materials: 1. 2X ~10Mm M3 Screws 2. 2X Medium Size **Outdoor** Command Strip #Assembly: 1. Remove All Screws From The C2 And Remove The Stock Mount (Be Careful Of The Gps Wire). 2. Loosen The Glue Holding The Gps Antenna In The Stock Mount And **Carefully** Remove It 3. Slide The Printed Mount Over The Remaining Case, Ensuring The Gps Antenna Is Seated In The Indention For It 4. Replace The Top 4 Stock Screws And Put 2 ~10Mm M3 Screws In The Bottom Screw Holes 5. Place Command Strips On The Flat Inner Face Of The Dash Mount 6. Align The Dash Mount Where You Want It Horizontally On The Screen. 7. Place The Hook On The Top Of The Car Display And Rotate Down Until The Command Strips Are Pressing Onto The Plastic. Be Sure The Adhesive Sticks As Low As Possible On The Back Of The Screen To Prevent Wobble
Statistics
Likes
0
Downloads
0