Elastomeric Coupling 0v0: 5mm stepper motor to 8mm threaded shaft
Description
<b><i>This thing is obsolete. Here is the next generation version: http://www.thingiverse.com/thing:7831 </i></b> This thing is an <b>experimental</b> printable elastomeric coupling designed for a molded and cured-in-place rubber insert. The rubber part is cured-in place RTV silicone sealer. It has robust clamping, and should be well balanced if tightened evenly. Heritage: This is a variation of: http://www.thingiverse.com/thing:7678 based on the suggestion there by JelleAtProtospace <b><i>================================= AFTER I BUILD AND TEST THIS THING, I THINK IT FAIL. Basically the silicone takes a long time to cure and is too soft. Overloads tend to make it want to go off center. I do not recommend making this thing.</i></b>
Statistics
Likes
41
Downloads
1358