Many Use Thing
Description
The Many Use Thing is a tool that I designed in Sketchup. It can be used for the following purposes: * Dremel collet tightening / loosening * 3/8" Socket Driver * 1/4" Socket Driver * 1/4" Socket hold for bits ------------------------------------------- To use as a Dremel collet tightener, slide the tool over the flat part of the collet and then squeeze the arms with your thumb and forefinger while twisting to tighten or loosen. The 3/8" and 1/4" drive shafts are for sockets. After printing they will need to be "broken in". Trim up excess plastic and force a socket on and off a few times. After that you can be assured that once a socket is put on it will not fall off. The hole in the middle is 1/4" so you can use it as a handle for bits. Photoset: http://www.flickr.com/photos/23450595@N02/sets/72157626847828041/ Video: http://youtu.be/c26OSuSRPE4
Statistics
Likes
210
Downloads
1851