Orca Series linear bearing lm8uu x-carriage - better/newest version
Description
This is a simpler version of my original design for the LM8UU x-carriage. It is intended to use with an Orca 0.3, but it can possibly also fit an Orca 0.2 (please let me know your experiences!). Version 5 updates: - Increased the length of the LM8UU holders - Decreased the width of the LM8UU holders Version 4 updates: - rounder at the belt holder to use complete print bed - other kind of holders which are stiffer - room for tiewraps in the holders to keep the bearings in place - moved bolt holes a bit so M4 bolts can be used - moved the belt clamp 1mm so the belt is 100% (candle ;p) straight Version 3 updates: - reinforced bottom plate a bit - added more bolt holes so it (could) be attached with 6 bolts Version 2 updates: - had to cut off one part of the belt clamp for the motor bolt to fit - made the belt clamps a bit wider to fit the belt more easily - made the LM8UU holders a bit tighter (now 24.00mm x 16.50mm dia) - rounded the edge of the belt holder to make it slide more to the right/left
Statistics
Likes
16
Downloads
2025