Printrbot Simple 1405 Stabilizing Legs (For Extended Beds)

Description

I Am Installing A 15 Inch Bed On My Printrbot Simple 1405, And This Will Cause Instability. The Printrbot Is Prone To Tipping When Not Using The Original Bed. I Created These Legs To Stop This From Occurring. They Use The Original Screw Holes On The Bot, You Will Require 6 Longer (20Mm) M3 Screws. With These Installed, I Can Put A Kilogram Of Filament On My Bed Without Tipping! They Are Printable On The Stock Bed And Are Printable Without Supports.

Statistics

Category

Tags