Gyro Eval Board Holder
Description
This Openscad Script Creates A Holder For An Stm Gyro Eval Board That Fits Onto The Moutign Holes On A Gyro_Turntable_Mounting_Plate So That It Can Be Tested On A High Speed Turntable Note: May Need To Trim Some Stuff From The Top Of The Cylindrical Posts As There Are Many Small Components Adjacent To The Screw Holes Changes From Previous Versions: V0.4 - Removed One Of The Bolt Holes Under Devices - Make It Thicker (From 3 To 5 Mm) So It Prints Better V0.3 - Adjusted Some Values Based On Callipers Based Measurements Of Board - Now It Should Be Realistically Sized V0.2 - Removed Junk Lines - Added Cutouts - Repositioned Parts - Added Minkowski Sum To Round Out Corners Under Pcb - Made It Into A Printable Item V0.1 - First Attempt At Laying Out Parts
Statistics
Likes
0
Downloads
0