2-axis GoPro Gimbal v3.0
Description
*7/20 Added Generic Frame Mount* *7/23 Added Custom Frame Mount [12.5Mm Holes, 50.5Mm Spacing]* This Is A 2-Axis Gopro Gimbal Made To Support The Gopro While Mounted Inside Of The Polycarbonate Enclosure. The Mounts Are Designed To Work With The Xaircraft Diy Frames. The Roll Mechanism Works On A Rail System And A Series Of Gears That Take The +/- 90 Degrees Of Servo Travel And Rotate The Inner Ring By +/- 55 Degrees. The Pitch Mechanism Is Directly Driven From The Servo. The Mount Is Made To Use Xaircraft Rubber Rings For Vibration Damping. If You Would Like To See The Mount Redesigned To Meet Alternative Specifications You Can Contact Me With Dimensions At Adam@Polakiumengineering.Com. Keep In Mind That This Was Designed To Be Printed In Polyamide Using A Zcorp Printer. The Attributes Of This Material Are As Follows: Layer Thickness Of 0.1Mm With A Detail Resolution Of 0.2Mm And A Recommended Wall Thickness Of 0.7Mm. If The Printer Uses Support Structure, The Material Must Be Able To Dissolve Away. More Information Found Here: Http://Polakiumengineering.Com/?P=1146 This Is Only A Prototype And Hasn'T Been Tested Because I Don'T Have Access To An Affordable Source For 3D Printing It.
Statistics
Likes
213
Downloads
0