Water Bottle Camera Stand, with Centered Lug
Description
This Thing Is A Simple Cap That Fits Over The Cap Of A Standard Water Or Soda Bottle, And Holds Your Small Snapshot Camera So You Can Take A Picture Without Having To Rest The Camera On A Stick, Railing, Etc. I Saw A Soda Bottle Tripod Thing Here On Thingiverse, But It Was Printed In 3 Pieces And Had To Be Glued Together. Plus It Was Thick And Bulky And Had A Pivot Ball That Didn'T Fit Into The Socket Correctly (It Broke The Socket When I Pushed It In). I Designed This Camera Stand Completely From Scratch Using Autodesk Inventor. I Printed It Out Using The Thing-O-Matic At Techshop And Also On A Replicator. The Little Post That Attaches To The Camera'S 1/4-20 Threaded Mount Simply Pushes In...You Don'T Have To Screw It In. I'M Not Sure How Many Cycles This Will Work, But You Can Always Print A New One If It Wears Out. Also, I Would Advise That You Unscrew The Mount From The Camera Instead Of Pulling It Straight Out...There'S A Chance It Could Break Off If You Pull It. Be Careful Because The Camera Might Be A Little Tippy On Top Of The Soda Or Water Bottle. Be Careful That The Wind Doesn'T Blow The Whole Thing Over And Break Your Camera! Enjoy!
Statistics
Likes
132
Downloads
0