Z-Axis Adjuster and Dial - Ultimaker
Description
This Is A Derivative Of Scottmayson'S Z-Axis Adjuster For The Ultimaker (Thing 19912). I Found That The Original Z-Axis Adjuster Body Was A Little Too Short For The Full Adjustment Range For My Ultimaker, So I Lengthened The Body By 10 Mm. The Other Parts Are All The Same. Since I Am Not Yet Adept At Modelling, I Just Used Netfabb Basic To Cut The Original Model Into 3 Parts And Elongated The Middle Body Part. After Aligning The Three Parts, I Exported Each Of The Stl'S From Netfabb, Imported Them Into Meshlab, Combined Them Into One Mesh And Simplified The Mesh. As A Final Step I Sent The Whole Thing To The Netfabb Cloud Service For Cleaning (Http://Cloud.Netfabb.Com/).
Statistics
Likes
15
Downloads
0