8040 Propeller Optimized for Printing, V1.0
Description
This Is A Redesign For An 8040 Printable Propeller With A 5.5Mm (13/64") Bore. This Prop Was Designed To Keep The Minimum Cross Section Above .8Mm Allowing It To Be More Easily Printed, Though At A Small Efficiency Loss. The Propeller Will Require Support On One Edge, Which Makes It Very Easy To Remove. I Can Redesign This For Some Different Center Hole Diameters If Requested, Just Give Me Some Time As I Am Pretty Busy. Here Is A Short Video With The Prop On A Motor: Http://Www.Youtube.Com/Watch?V=V6Yclt12Ges&Feature=Plcp I Will Also Be Uploading A 5030 Prop Once It Is Flight Tested. I Printed Mine On A Fablicator Using Kisslicer.
Statistics
Likes
1409
Downloads
0