Printrbot Metal Spool holder for Printrbot spools
Description
After Some Discussion With Walter (Wanderson), It Turns Out That The Original Design Is Too Narrow For A Printrbot Spool And 0.75Mm Too Short For A Makerbot Spool. This Is A Slight Re-Design Which Covers Both Of These Issues Allowing For Spools That Have A Width Of Just Under 90Mm And A Measurement From The Outside Of The Spool To The Opposite Part Of The Inner Hole Of 130Mm. The Design Is Still Small Enough To Fit Within The Build Volume Of The Printrbot Metal And Can Be Printed Without Support.
Statistics
Likes
25
Downloads
0