Enclosure Box for your Arduino RFID-Project
Description
Do You Need An Enclosure For Your Rfid Project? This Is A Tab-In-Slot Design For A Laser Cut Box That You Might Want To Use Or Re-Appropriate For Your Needs. - Dimensions Are 150 X 150 X 50Mm, Fits An Arduino Microcontroller With An Ethernet Shield Attached To It, As Well As An Rfid Controller And Antenna. - Little Base For The Rfid Antenna To Sit Right Behind The Front Panel (+ Extra Base If You Use The Id-20 Rather Than Separated Rfid Controller And Antenna) - Pre-Cutted Pcb Standoff Holes For The Arduino And Rfid Controller - Holes In The Back Of The Box For A Power Adapter, Ethernet Cable, And A Piezzo-Speaker For Auditive Feedback After A Card Was Read - Tab-In-Slot Design With Cutouts For An Interlocking T-Bolt Construction To Stabilize The Box Using 3Mm X 10Mm Machine Screws And 3Mm Nuts.
Statistics
Likes
77
Downloads
0