#Connector piece for Bourgie Kartell lamp
Description
So A Relative Of Mine Knocked Over Hers, Rather Expensive, Bourgie Kartell Designlamp. Causing The Foot Of The Lamp To Break In 3 Peaces. After Examining The Break I Noticed That Only A Removable Plastic Connector Piece At The Bottom Was Broken. Glueing The Piece Did Not Help, Because On Reassemble The Piece Would Just Break Again Due To The Tension. Therefore I Made A 3D Model Of The Piece. I'Ll Print The Model In A Fablab Next Week And Hope To Fix The Lamp With The Replacement Piece! I Figured It Couldn'T Hurt To Upload The Model To Thingiverse. Who Knows Someone Else Here Broke Theirs Bourgie Lamp :) Update: I Printed The Part In A Local Fablab On A Up! Mini. The Part Printed Very Nice. Unfortunately The Part Did Not Fit Exactly In The Lamp. The Arch Were The 3 Outside Cilinders Connect To The Center Cilinder Was Hard To Copy Exactly, So This Was A Bitbto Think. But With A Litlle Sanding The Part Fitted Nicely Resulting In 1 Fixed Lamp! I Will Try And Edit The Model So The Part Fits Directly From Print. Update 2: I Uploaded A Version 2 Of The Connector. This Part Should Fit Directly Without Sanding.
Statistics
Likes
9
Downloads
0