UPDATED E-stop knob, parametric-ish
Description
This Is Designed To Replace The Standard Black Knob On A Push-Off Pull-On Switch. I Will Be Using It To Control The Atx Power-On Line, I.E. Pin 13 To Ground To Turn The Power Supply On. It Will Be Part Of My Printbot Control Panel, A Wip. I Can'T Recall Where I Got The Switch, But Presume It Was In My Local Car Accessories Shop. These Are What Old Cars, Really Old, Used As Headlight Switches. Without Relays. <B>Note:</B> Technically This Switch <I>Would Not Qualify As A Safety Switch</I>, But For Me It Will Be Enough For 12/24Vdc. Update Feb 2013. I Finished Painting My Print Room And Have Been Able To Print Some Things, Including This. V0-3 Didn'T Work Out Well, See Photos. So I Now Have V0-4 With Higher Raised Lettering (Or Parameter To Recess), And Wider At 17.5Mm. Looks Much Better. I Also Changed My Slic3R Retraction Movement To 1Mm, Prints Much Cleaner, Compare The Middle One To The Righthand One In The Photo. Tip: When Utilising Write.Scad, Use 'Include' Not 'Use' As There Are Variables Which Don'T Get Set When You Use 'Use'.
Statistics
Likes
16
Downloads
0