Low Polygon Mask - Replicator Printable
Description
Need A Masquerade Mask, But Just Can'T Quite Fit The Low Polygon Mask Into Your Replicator Print Volume? Well, Stop Fretting And Use Openscad To Trim Some Tiny Edges Off! 2013-01-01: At The Last Minute I Slapped Together And Printed A Stick That Worked Quite Well As A Handle (Once A Little Silver Duct Tape Was Added On The Inside Of The Mask). It'S Not Perfect, But For Being A Ten-Minute Design It Worked Very Well! 2013-01-02: Fixed The Gap In The Cc License-Chain By Switching From Cc0 To Cc-By-Nc-Sa.
Statistics
Likes
1167
Downloads
0