R.A.T. 5 pinky board
Description
Obsolete For Now! Make : Http://Www.Thingiverse.Com/Thing:79303 Thanks @ Doxin For The Edit! This Is A Pinky Board For The R.A.T. 5 Mouse. I Love That Mouse, However I Was Missing A Place To Rest My Pinky. Now I Saw That A Higher Tier Model Had The Stuff, But It Was Nowhere To Be Found As A Separate Item. So I Decided To Make This For Myself (Plus, It'S A Nice Exercise On The 3D Modelling). I Printed A Preliminary Design I Had, Which Fitted Like A Charm. However, It Didn'T Have The Bolt-Hole And The Supports. This Is Yet To Be Printed, Which Will Be When I Visit My Makerspace Again. Therefore A "Work In Progress". After Printing I Found Out One Of The Holes Didn'T Line Up 100%. Another Thing I Noticed Was That The Lower Side Sits A Little Too Low Compared To The Bottom Of The Mouse. It Hits The Mouse-Mat Instead Of The Ptfe. Brought Up The Whole Fingerboard A Tad. To Let The Design Fall More In Line With The Thumb-Side I Cut A Bit Of The Board. Should Look Better. Change-Log For 5.2: - Slight Fitting Adjustments - Added More Clearing For The Fingerboard - Shortened Fingerboard -Big Goof On The Alignment, Ought To Be Fixed. Moved Screw Hole Up 3Mm. I Edited The Part, But (As Before) I Can'T Tell If It Works Yet Because I Haven'T Printed Yet.
Statistics
Likes
15
Downloads
0