Nozzle cleaning tool
Description
This Is A Toothpick Holder Designed To Make Cleaning Your Replicator 2 Extruder Nozzle, Quick And Effective. With The Extruder Drive Assembly Removed And The Nozzle Pre-Heated, You Insert Trimmed Toothpicks Into The Top Of The Hot End With A Circular Downward Motion. Repeat The Process To Clear Out Any Burnt Pla Until The Toothpicks Come Out Clean. Then Use A Sanded Down Pin To Clean Out The 0.4Mm Nozzle Tip. The Whole Process Takes About 15 Minutes. This Toothpick Holder Was Designed Using An Acis Solid In Shark Fx/Viacad (Vc3 File Included) So Will Behave Well With Makerware, Replicatorg And Skeinforge.
Statistics
Likes
542
Downloads
0