Auto-level sensor holder, for printrbot Simple 2014
Description
My Original Version Of The Probe-Sensor Holder, Distorted Badly With Heat, See Last Picture. So I Had Another Go. This Time I Decided To Strengthen The Holder With Some Metal Support. I Originally Was Thinking Of Using Coathanger Wire, But A Look In My Odds And Ends Draw Found A 65Mm Nail, It'S 2.5Mm Diameter. This Nail Sits Inside The Main Body. I Have Used It For About A Week Now And Whilst It Has Bent Slightly, I Believe It Will Hold Up. With Only A Week Of Test Time This Will Stay As A Work In Progress For Now. This Is For The Printrbot Simple 2014 With Wooden Extruder. 28/05/2015 I Never Did Get Auto-Levelling To Work Consistently, Go Here To See How I Went Back To Manual Levelling. Bed Levelling/Height Adjusting Screw/Clips Http://Www.Thingiverse.Com/Thing:850245
Statistics
Likes
5
Downloads
0