Wensi PV layer holder
Description
This Openscad Script Will Generate A Simple One Piece Fixture To Hold Wensi'S Pv Layer'S Pv Cell, Pcb And Supercap. This Is Using The Slightly Newer Layout And Scap Propsed On The 17Th August 2011 Author: Mark Gaffney Version: 2.2 Date: 2011-09-16 Todo: Add Thin Infill For Hollow Sections To Improve Printability Make Slide In Pv Version Make 2X Corner 1 Middle Tab Pv Version Make Screw Post Pcb Version Make Pin Post Pcb Version Make Mushroom Post Pcb Version Move Holes For Scap Pins (2X Dia=0.6+Blah Separation=~10-Blah Dist_From_Bottom~=2.5-Blah Dist_From_Sides=5-Blah) And Pv Wires To More Logcal Place, Also Change To Square, Triangle Or Teardrop Shape For Better Printability Remember The Scap Is Now A Table Profile With Dia~=10.5 Warning: There Is No Top Part For This Changes From Previous Versions: 2.2 - Change Cutout For Trapezoidal/Pyramidal Shape 2.1 - Fixed Some Vlaues To Place The Support Posts In Corect Location (Up +1Mm) Scap Leads Right +2Mm - Increased Post Diameter For The Two Along One Side Slightly 2.0 - New Layout (Pcb Rotated 90Degrees) And Larger Scap - Change Pcb_L 30->35 Pcb_B 35->30 - Change Scap_L 23->20 Scap_B 15->22 Scap_H 5->10 0.8 - Add Thin Infill For Hollow Sections To Improve Printability 0.7 - Moved Entire Structure Above Z=0 Plane (No Longer A Destroyer Of Belts) - Added Mouse Ears 0.6 - Made Thinner - Fixed Incorrect Measurements For Pv Panel 0.5 - Added Holes For Wires Between Sections 0.4 - Removed Plastic From Centre Of Pv Area To Speed Up Print 0.3 - Fixed Error With Cutout Translates Due To Misuse Of Separation And Clearance Variables - Fixed Error With Second Half Of Calculation Of Total _B Using Max() Where I Forgot To Include Separation 0.2 - Added Support Posts 0.1 - First Attempt
Statistics
Likes
2
Downloads
0