Winterfell Dual Extruder Version
Description
I Love Damm301'S Winterfell And It'S Relatively Easy To Swap The Filament After The Base Finishes To Get Two Colors But I Have A Dual Extruder And Wanted To Take Advantage Of That. I Also Fixed The Pathway Which Overhangs On The Front. If Using Makerware Remember To Say 'No' When It Tries To Put The Top Part On The Print Bed. I Did This At 5% Fill, 2 Shells, .1 Layer And 50Mm/S. I Think It Could Benefit From Printing Slower. * There Is Another Dual Print On Thingiverse But It Had Flipped Normals And Most Of The Base Plate Still Attached To The Buildings.
Statistics
Likes
222
Downloads
0